Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Nächste Überarbeitung | Vorhergehende Überarbeitung | ||
brother [2015/08/24 21:17] admin angelegt |
brother [2015/08/24 21:54] (aktuell) admin [Drum Led blinkt] |
||
---|---|---|---|
Zeile 8: | Zeile 8: | ||
Drum counter zurücksetzen | Drum counter zurücksetzen | ||
- | 1.Remove the drum unit and toner cartridge. Wait 1 or 2 minutes. | + | http://www.zinetic.co.uk/brother_hl_2030___2030b_drum_unit_reset_instructions-details.aspx |
- | 2.Replace the drum unit and toner cartridge into printer. | + | |
- | 3.The Drum LED continues to blink if the drum counter was not reset when you replaced the drum. We need to reset this now! | + | 1. Remove the drum unit and toner cartridge. Wait 1 or 2 minutes. |
- | 4.Open the front cover of the printer | + | 2. Replace the drum unit and toner cartridge into printer. |
- | 5.Press and hold down Go button for about 4 seconds until all the LEDs light up. | + | 3. The Drum LED continues to blink if the drum counter was not reset when you replaced the drum. We need to reset this now! |
- | 6.Once all 4 LEDs are lit, release the Go button | + | 4. Open the front cover of the printer |
- | 7.Close the front cover. | + | 5. Press and hold down Go button for about 4 seconds until all the LEDs light up. |
- | 8.Your drum is now reset. | + | 6. Once all 4 LEDs are lit, release the Go button |
+ | 7. Close the front cover. | ||
+ | 8. Your drum is now reset. | ||
+ | |||
+ | ===== Brother HL-5450DN ===== | ||
+ | |||
+ | Um einen Toner manuell zurückzusetzen, versuchen Sie folgende Prozedur: | ||
+ | |||
+ | 1. Gerät ausschalten, Frontklappe öffnen. | ||
+ | 2. GO-Taste gedrückt halten, einschalten und warten bis alle LED’s leuchten, einzig die Ready-LED erlischt. | ||
+ | 3. GO-Taste loslassen. | ||
+ | 4. GO-Taste 2x drücken (2 Sekunden warten). | ||
+ | 5. GO-Taste 5x drücken (Starter Toner) oder 6x drücken (Standard Toner). | ||
+ | 6. Frontklappe schließen | ||
+ | |||
+ | Wenn auch damit kein Reset des Toners bzw. der Anzeige möglich ist, sollte das Gerät von einem Techniker überprüft werden. | ||
+ | Dazu wenden Sie sich an unsere Service-Hotline (Tel.:01-61013-4360) oder direkt an einen Servicepartner in Ihrer Umgebung. | ||
+ | Hier der Link zur Suche: http://www.brother.at/support/service-center-austria | ||